What Is The Asme nm500 steel equivalent?

SA516Gr60 material, SA516Gr70, SA516Gr60N, SA516Gr70N steel plate in thickness ≤1.5in (40mm) is usually supplied in rolled state. The plate can also be ordered according to normalizing or stress relief, or normalizing plus stress relief. SA516Gr60 steel plate when thickness> 1.5in. (40mm) should be normalized. Unless otherwise specified by the customer, NM500 steel equivalent, SA516Gr60 steel plate (thickness ≤40mm) should be normalized when there is a notch toughness requirement.

The company is based on the principle of good faith, small profits and quick sales, and keeps forging ahead. In the fierce market competition, with NM500 steel equivalent good cooperation and sincere service spirit, we win the trust of our customers and develop rapidly. We will create a win-win situation with our customers and create a better future with the belief of pioneering, pursuing excellence and learning.

Processing performance of quenched and tempered steel: NM500 steel equivalent plate can be used for cold working, bending and cutting. When the gas is cut off, cracks will not occur even without preheating. When preheating processing, quenched and tempered steel needs to be processed below the tempering temperature. Superb wear and corrosion resistance: Because it contains alloy elements such as copper and chromium, it has good corrosion resistance, higher hardness, and good wear resistance compared with ordinary steel.

Low alloy high strength steel is a kind of engineering structural steel developed by adding a small amount of Mn, Si and a small amount of Nb, V, Ti, Al and other alloy elements on the basis of carbon structural steel, NM500 steel equivalent. The so-called low alloy means that the total amount of alloying elements in steel is less than 3%. High strength is relative to carbon engineering structural steel. The development principle of low alloy high strength steel is to use as few alloy elements as possible to obtain as high comprehensive mechanical properties as possible, so as to meet the requirements of use and low cost.

We should focus on the main problems to be solved and pay attention to efficiency. After receiving the user's quality objection report data, the possible causes, responsible units, compensation amount, etc. of the problem shall be judged based on experience. To have a clear service plan, to be clear about what your main problem is, what technical support is needed, these should be prepared.