The application of hardox 400 thickness range is expanding

The wear-resistant plate HARDOX 400 thickness range shows good wear resistance: the chemical composition of the alloy layer contains 4-5% carbon and 25-30% chromium. The volume fraction of Cr7C3 carbide in the metallographic structure is more than 50%, the macro hardness is HRC56-62, and the hardness of chromium carbide is HV1400-1800. Because of the vertical distribution of carbides in the wear direction, the wear resistance of the cast alloy with the same composition and HARDOX 400 thickness range hardness is more than twice as that of the cast alloy with the same composition and hardness. Compared with several typical materials, the wear resistance is as follows: (1) compared with low carbon steel; 20-25:1 (2) with as cast high chromium cast iron; 1.5-2.5:1.

Many people will mix strip steel and steel plate together, which can usually be distinguished from the following points. First of all, the thickness of the steel plate is much thicker, and the thinner the strip steel is required, the better. Secondly, in appearance, the steel strip can be crimped and the steel plate is too thick to bend, even if it is bent, it is difficult to recover, because it is easy to break if it is bent too much. Thirdly, the strength of HARDOX 400 thickness range, steel plate is higher than that of strip steel. The steel plate is suitable for construction engineering, while strip steel is only suitable for processing into hardware products.

If customers have any difficult problems during use of the steel materials, they can contact the company's after-sales service department to feedback the existing problems. The after-sales department will reply as soon as possible to ensure that each customer has a good after-sales experience. Under special circumstances, the after-sales service department will start the problem-solving process, and the engineers in charge of the area will quickly follow up to solve the problem.

Plasma cutting has a wide range of applications. With different working gas, it can cut various kinds of metals that are difficulty to handle by oxygen cutting. Plasma cutting is fast and efficient when cutting metal with small thickness. The HARDOX 400 thickness range cutting speed can reach more than 10m/min. Plasma cutting can get a clean, neat, non stick slag cutting surface, while the deformation and thermal effect of the incision are small, its hardness change is little, and the cutting quality is good.