nm400 material technical data sheet

The blanking of the structural steel plate is first to find 90 degrees, and then use a tape measure and a powder line to draw the cutting range. According to the thickness of the carbon steel plate plus the cutting allowance, drilling is required. For the deep processing of NM400 material structural steel sections or profiles: First use a square ruler or a curved ruler to find 90 degrees, and then use a square ruler or a ruler to cut the line and add the cutting margin to the hole.

Large-thickness NM400 material, Z35 grade steel plate is a kind of extra-thick steel plate that is applied under specific environmental conditions, such as the key parts such as the turbine seat ring and guide vane of the generator set. It has high requirements for safety, reliability, and long service life. Develop 200mm-300mm thick steel plate of Z35 level, to ensure that the layer tear resistance reaches Z35 level. 300mm thick Z35 grade steel plate can be used not only in the hydropower industry, but also in the manufacture of other large key equipment, and has broad prospects.

NM400 material, Wear resistant steel plate is a kind of special plate product used under the condition of large area wear. At present, the commonly used wear-resistant steel plate is made by cladding a certain thickness of alloy wear-resistant layer with high hardness and excellent wear resistance on the surface of ordinary low-carbon steel or low-alloy steel with good toughness and plasticity. In addition, there are cast wear-resistant steel plate and alloy quenching wear-resistant steel plate.

After more than 20 years of ups and downs in the steel industry, BBN company's customers have covered South America, North America, Europe, Africa, Southeast Asia and the Middle East and other countries and regions. We treat every customer who inquires with us sincerely, whether you cooperate with us or not, we will provide you with the best quality steel solutions. Our company team also support the online customer service.