ASTM equivalent of hardox 450 plate high quality

Standing at a new historical starting point, we adapt to the requirements of supply side structural reform, adhere to the overall strategy of "innovation driven, quality leading, Hardox 450 plate high quality quality improving and efficiency increasing, transformation and development", and constantly improve the development concept and development level with a forward-looking vision and grand vision. Now we have been ranked the Hardox 450 plate high quality International leading steel materials supplier.

Generally, the production process of Hardox 450 plate high quality seamless steel tube can be divided into cold rolling and hot rolling. The production process of cold-rolled seamless steel tube is generally more complicated than that of hot rolling. The tube blank must be first rolled by three rolls, and then be subject to sizing test and cutting after extrusion. Then enter the annealing process. In appearance, the cold-rolled seamless steel tube is shorter than the hot-rolled seamless steel tube, and the wall thickness of the cold-rolled seamless steel tube is generally smaller than that of the hot-rolled seamless steel tube, but the surface looks brighter than the thick wall seamless steel tube, the surface is not too rough, and the diameter is not too much burr.

What is the specific use of Hardox 450 plate high quality, hot rolled plate in daily life? First of all, hot rolled plate is used in bridge, vehicle structure, frame and other fields to play a role of bearing pressure. Secondly, high pressure boiler vessels are also made of hot rolled plates, which can be heat-resistant and airtight, and can stably seal the hot gas in the container. Thirdly, stainless steel hot rolled plate can be used to process hardware products. It has excellent corrosion resistance, and is easy for processing.

The preparation of Hardox 450 plate high quality galvanized steel before welding is the same as that of ordinary low-carbon steel. It is necessary to carefully handle the groove size and nearby galvanized layer. In order to achieve penetration, the groove size shall be appropriate, generally 60 ~ 65 °, with a certain gap, generally 1.5 ~ 2.5mm; in order to reduce the penetration of zinc into the weld, the galvanized layer in the groove can be removed before welding. In the practical work, the centralized beveling, no blunt edge technology for Hardox 450 plate high quality centralized control, two-layer welding process, reducing the possibility of incomplete penetration.

Hardox 450 plate high quality, P355GH plate mechanical properties: P355GH steel plate thickness/mm:> 60-100: tensile strength σb / MPa: 490-630; yield strength σx / MPa:> = 315 Impact absorption energy AKv / J:> = 34. Steel plate thickness / mm:> 100-150: tensile strength σb / MPa: 480-630,y ield strength σx / MPa:> = 295 Impact absorption energy AKv / J:> = 34. Chemical composition % (C:0.10-0.22, Si:<=03.60, Mn:1.00-1.70, Nb:<=0.010, Ti:<=0.03 S:<=0.030, P:<=0.025, Cr:<=0.30, Ni:<=0.30, Cu:<=0.30, Mo:<=0.10, V <=0.02)

We should focus on the main problems to be solved and pay attention to efficiency. After receiving the user's quality objection report data, the possible causes, responsible units, compensation amount, etc. of the problem shall be judged based on experience. To have a clear service plan, to be clear about what your main problem is, what technical support is needed, these should be prepared.