xar400 wear resistance material Material Specification

Can xar400 wear resistance material, 40Cr material be replaced with 40MnB steel? 40MnB steel is used to manufacture small and medium-sized important quenched and tempered parts in tractors, automobiles and other general machinery and equipment, such as automobile half shafts, steering shafts, spline shafts, worms and machine tool spindles, gear shafts, etc. 40MnB steel can replace 40Cr material to make parts with larger cross-sections, such as the middle shaft of a hoist. And 40MnB steel can replace 40CrNi steel when making small-sized parts.

In recent years, in line with the development trend of iron and xar400 wear resistance material steel industry at home and abroad, we have accelerated the transformation of development mode, promoted structural adjustment, and formed a rich product series of medium and thick plates, hot rolled steel coils, profiles, steel pipes, etc., which xar400 wear resistance material are widely used in automobiles, long-span bridges, railways, machinery, ocean and so on fields. Meanwhile, we also provide deep processing for the steel materials.

During the construction of hot-dip xar400 wear resistance material galvanized pipe, the correct welding process shall be adopted, the inspection and acceptance shall be carried out in strict accordance with the specification, and the anti-corrosion treatment (zinc rich paint) shall be done timely after the welding is completed. It is feasible in the construction process of open and closed air conditioning system, which can improve the xar400 wear resistance material construction speed and the firmness of the pipe connection. Therefore, the hot-dip galvanized pipe can be welded and connected under the construction conditions and on the premise of relevant protection and anti-corrosion measures.

Laser cutting is that the horizontal laser beam emitted by the laser changes into a vertical downward laser beam through the 45° total reflector, and then focuses through the lens, forming a tiny spot at the focal point. When the spot hits the material, the material is heated to the vaporization temperature quickly, and evaporates to form a hole. With the movement of the beam on the material such as xar400 wear resistance material, the auxiliary gas (carbon dioxide gas, oxygen, Nitrogen, etc.) blow away the melted slag, make the hole continuously form a very narrow width (such as about 0.1mm) cutting seam, and complete the cutting of materials.

Our company will accept the product quality objection registration record, pass it to the xar400 wear resistance material production unit and relevant departments, and timely coordinate the supervision of product xar400 wear resistance material quality objection. Our company coordinates the relevant department personnel to the customer unit to carry on the investigation, the processing.