Will raex 500 sheet material prices be consolidated

Standing at a new historical starting point, we adapt to the requirements of supply side structural reform, adhere to the overall strategy of "innovation driven, quality leading, quality improving and efficiency increasing, transformation and development", and constantly improve the development concept and development level with a forward-looking vision and grand vision. Now we have been ranked the International leading steel materials supplier.

S355J0 steel is a low alloy structural steel. We can supply S355J0 structural steel plates up to 400mm, with a minimum yield strength 355MPa when plate thickness less than 16mm, min. yield strength 345MPa when plate thickness range 16mm to 40mm. Without any special rolling or heat treatment for S355J0 steel plate and sheet, , the abbreviated designation of this delivery condition shall be AR (As rolled).

After quenching and tempering, 40Cr alloy steel plate and raex 500 sheet material sheet have good comprehensive mechanical properties, good low temperature impact toughness and low notch sensitivity. The hardenability of steel raex 500 sheet material is good. It can be hardened to Ф28 ～ 60mm during water quenching and Ф15 ～ 40mm during oil quenching. In addition to quenching and tempering, this steel is also suitable for cyanidation and induction hardening. The cutting performance is better. When the hardness is HB174 ～ 229, the relative cutting workability is 60%. 40Cr alloy steel is suitable for making medium-sized plastic molds.

Raex 500 sheet material,Titanium microalloying is an element of strengthening complex with carbon and nitrogen. The addition of micro amount of titanium in the steel can fix almost all nitrogen and part carbon in the steel, so as to eliminate the strain aging phenomenon and improve the aging impact performance of the steel. At the same time, it can refine the grains and change the morphology of the compounds. According to the atomic weight ratio of Ti and N in tin formula (Ti = 3.4n), the content of Ti in steel should be controlled between 0.015 and 0.025%. Generally, the amount of ferrotitanium added to each ton of steel is 1kg.

Raex 500 sheet material,A572 Grade 50 steel with the thickness range is 1.2-600mm, the width range is 1220-4200mm, and the length range is 5000-18000mm. Also note that the A572 Grade 50 steel coil thickness should not exceed 25 mm. For A572 Grade 50 steel, the C element content is 0.23%, the Si element content is 0.4% max, the Mn element content is 1.35% max, the P element content is 0.004% max, the S element content is 0.05% max, the V element content is 0.06%, the Ni element content is 0.015%, the Co element content is 0.05%.raex 500 sheet material

Raex 500 sheet material,The after-sales service personnel understand the user's ideas and needs in detail, and stand on the other side's position and interests. Actively communicate with users and help them solve practical problems. This not only solves the service problem, but also improves the customer's trust in the company.raex 500 sheet material