Introduction NM450 plate material or NM450 plate material materail

ASTM A633 standard covers four grades A, C, D, and E normalized high-strength low-alloy structural steel plates for welded, riveted, or bolted construction. NM450 plate material, A633 Grade A structural steel provides a minimum yield point of 42 ksi [290 MPa] in thicknesses through 4 in. [100 mm], inclusive. Grades C and D provide a minimum yield point of 50 ksi [345 MPa] in thicknesses up to 2.50 in. [65 mm], inclusive and 46.0 ksi [315 MPa] in thicknesses over 2.50 in. to 4.0 in. [65 to 100 mm], inclusive.

In terms of service, our service is a "one-stop" way of working. We have our own NM450 plate material processing plant and pretreatment plant, pretreatment of ship steel (shot blasting, derusting, painting). Technical parameters of steel plate and profile steel surface pretreatment production line. We can also let customers enjoy our other pretreatment services, such as NM450 plate material cutting, welding, drilling, galvanizing, etc., at the lowest cost.

Weathering steel generally adopts the process route of fine material into the furnace-smelting (converter, electric furnace-microalloying treatment-argon blowing-LF refining-low superheat continuous casting (feeding rare earth wire)-controlled rolling and cooling. The scrap steel is added into the furnace together with the charge, and smelted according to the conventional process. After the NM450 plate material steel is tapped, deoxidizers and alloys are added. After the molten steel is treated with argon blowing, the molten steel is cast. By adding rare earth elements to the steel, the NM450 plate material weathering steel is purified and the content of inclusions is greatly reduced.

Corrosion resistance of stainless steel mainly owes to the formation of a very thin, adhesive and translucent chromium oxide film on the surface of stainless steel. Once the film is damaged, the chromium in the stainless steel will react with oxygen in the atmosphere to restore the film quickly. At the same time, the mechanical damage can also generate a protective film quickly to prevent the NM450 plate material, stainless steel from corrosion.

When providing technical services on site, the after-sales personnel shall strictly abide by the safety rules and regulations of the construction site, consciously take safety protection measures (such as wearing safety helmet when entering the construction site), accept the supervision and management of the site; without permission on the construction site, they shall not dismantle, smear or damage any goods; the commissioning of contract goods shall be carried out under the supervision of the site supervisor If necessary, it shall be approved by the site supervisor or the person in charge of the project department.