How to choose hot rolled raex 500 vs hardox 500 supplier

The company now has raex 500 vs HARDOX 500 oversea market department, sales and supply department, finance department, logistics department, technical equipment department, quality management department, production department and other departments. The staff with college degree or above accounted for more than 80%, and there were more than raex 500 vs HARDOX 500 30 professional and technical personnel. The LSAW pipe production line can produce welded pipes with Φ350-1800mm, wall thickness 6-80mm, and length 2-12m.

Q420q material is a kind of structural steel plate for bridges, and there are three quality levels Q420qD, Q420qE and Q420qF. When the Q420q plate is required to have the performance in the thickness direction, the symbols Z15, Z25, Z35 representing the performance level in the thickness direction are added after the above-mentioned grades. Namely Q420qDZ15, Q420qDZ25, Q420qDZ35, Q420qEZ15, Q420qEZ25, Q420qEZ35, Q420qFZ15, Q420qFZ25, Q420qFZ35.

Compared with raex 500 vs HARDOX 500, boiler steel plates should have the following properties: (1) High medium temperature strength: low and medium pressure boiler drums use steel with a lower yield point, high pressure boilers use steel with a high yield point. (2) Good plasticity, impact toughness, cold bending and welding performance. (3) The notch sensitivity is small, that is, the sensitivity to the stress concentration caused by the opening of the steel plate surface and the welding of the pipe head is small.

For stainless steel plate cutting, the choice of cutting method is determined by the thickness of steel plate. If the thickness of raex 500 vs HARDOX 500 stainless steel plate is more than 20 mm, flame cutting is adopted, while the thin plate is suitable for plasma cutting. In addition, if the cutting requirements are relatively high, laser cutting can be used. In addition, if the raex 500 vs HARDOX 500 stainless steel plate is used as a billboard, plasma cutting is adopted, Because it uses thin plates.

20Mn2 steel has medium strength, and the properties of 20Mn2 steel and 20Cr steel are similar. The impact toughness and weldability of 20Mn2 steel at low temperature are better than those of 20Cr steel. The plasticity and machinability of 20Mn2 steel are high during cold deformation. The hardenability of 20Mn2 steel is higher than that of corresponding carbon steel, raex 500 vs HARDOX 500. Chemical composition of 20Mn2 steel: C: 0.17-0.24, Si: 0.17-0.37, Mn: 1.40-1.80. Mechanical properties of 20Mn2 steel: tensile strength ≥ 785 MPa, yield strength ≥ 590 MPa, elongation after fracture ≥ 10%, section expansion rate ≥ 40%, impact absorbed energy ≥ 47J.

The after-sales service department will pay return visit to each customer by call or email, report problems found during the return visit in time, and discuss with the production and quality inspection center to propose effective solutions and follow up in a timely manner, so as to ensure the benefits each customer are fully guaranteed, and to provide customers with more value-added services.