Heat treatment of хардокс 400 equivalent material

The steel such as хардокс 400 equivalent material delivered in the hot-rolled state has a certain degree of corrosion resistance due to the high temperature, so it can be stored in the open air. However, this layer of oxide scale also makes the hot-rolled steel surface rough and the size fluctuates greatly. Therefore, the steel with smooth surface, accurate size and good mechanical properties is required to be produced by using hot-rolled semi-finished products or finished products as raw materials and then cold rolling.

The purpose of complete annealing of хардокс 400 equivalent material, wear-resistant plate is to improve the bad structure, such as coarse grain, widmanstatten structure (coarse ferrite with directional growth along with coarse grain) or banded structure caused by high temperature during hot forging, hot rolling, welding or casting of steel plate, so as to refine grain, improve mechanical properties, and reduce stress and hardness.

The company has a group of experienced steel plate continuous processing line construction, production management, operation and professional and technical personnel. The company is a modern enterprise integrating scientific research and development, production processing, sales and service. Our main products include hot rolled plates, seamless pipes, хардокс 400 equivalent material and steel structures. At the same time, it also adheres to international standards and adheres to the international line.

The mechanical properties of hot rolled steel plate are far less than that of cold working and forging, but the хардокс 400 equivalent material, hot rolled steel plates have better toughness and ductility. Cold rolled steel plate has a certain degree of work hardening and toughness is low, but it can achieve a better yield ratio, and can be used for cold bending spring leaf and other parts. At the same time, because the yield point of cold rolled steel plate is close to the tensile strength, the danger is not foreseen in the use process, and accidents are prone to occur when the load exceeds the allowable load.