Carbon structural GB stadard of nm500 steel for seamless steel pipe

A203GrD steel plate belongs to ultra-low temperature container plate. ASTM A203 is a low-nickel alloy steel, including five grades A, B, D, E, and F. Among them, Grades D, E, and F have a nominal nickel content of 3.5%, commonly known as 3.5Ni steel. A203D/E/F steel has good impact toughness and mechanical properties in a low temperature environment, and is usually used in a low temperature environment of -70～-101℃ (the tempered state can reach -107℃).

With the development of China's GB stadard of NM500 steel market economy, the company vigorously implements the strategy of industrialization, internationalization and diversification, promotes group operation, intensive development and lean management, and builds the company into a company with scientific development concept, continuous innovation vitality, excellent corporate culture and strong sense of social responsibility through rich series of GB stadard of NM500 steel products and project portfolio and complete operation network And international first-class competitiveness of modern enterprises.

The preparation of GB stadard of NM500 steel galvanized steel before welding is the same as that of ordinary low-carbon steel. It is necessary to carefully handle the groove size and nearby galvanized layer. In order to achieve penetration, the groove size shall be appropriate, generally 60 ~ 65 °, with a certain gap, generally 1.5 ~ 2.5mm; in order to reduce the penetration of zinc into the weld, the galvanized layer in the groove can be removed before welding. In the practical work, the centralized beveling, no blunt edge technology for GB stadard of NM500 steel centralized control, two-layer welding process, reducing the possibility of incomplete penetration.

Z-direction steel refers to thick steel with good tensile resistance in thickness direction. In the application of steel plate, the reason for additional performance requirements on the thickness direction of steel is due to the existence of defects in the thickness direction of steel in the process of casting and rolling. This defect makes the steel prone to lamellar tearing during welding, which reduces or even loses the design bearing capacity of application. The Z-direction performance is required for GB stadard of NM500 steel and so on steel plate with the tensile force along the plate thickness direction greater than or equal to 40mm.

After the order is finished, our after-sales service center will send an email to make a feedback about our steel products' quality. We have phone service every three months to remind our customers of the possible problems and collect advices or suggestions in quality and service. Upon the collection of advices or suggestions, our after-sales service will quickly make technical solutions to wipe out the customer problem.