Turkey nm450 steel elongation top 5 manufacturers

X-rays or γ-rays are projected on the surface of the steel plate, and rubber can be placed on the other side of the steel plate. Since the radiation propagates through the steel plate and is absorbed, the intensity is different due to the presence or absence of defects, so the film can record the shape and position of the defects. This NM450 steel elongation method is sensitive to the detection of common steel plate defects such as slag inclusions, porosity and pores. The disadvantage is that it is difficult to find the specific depth of the defect and it is not easy to find cracks.

BBN steel NM450 steel elongation 15mm to 35mm thick size: 15*2120*5620, 17.5*2320*13000, 18*2450*5500, 20*3000*5000, 19*2580*4700, 19.5*1970*4000, 20*1600*7740, 20.5*2370*7000, 21*2650*7500, 21*1920*8220, 22*1380*7650, 22*1800*8000, 22.5*1680*8450, 23*3000*11980, 23.5*2080*8100, 24*1560*6200, 25.5*2330*8300, 26*3010*8100, 26.5*2000*7000, 27*2550*6800, 27.5*2700*5500, 29*2550*9000, 29*2870*12000, 32*3300*6000, 33*2340*6700, 34*2120*6100, 35*1300*4100.

In order to further promote the ultra-low emission process and the technological innovation of flue gas treatment technology in China's steel industry, the China Institute of Metals and Beijing China-Japan Energy Conservation and Environmental Protection Engineering Technology Co., Ltd. (hereinafter referred to as Beijing China-Japan Alliance) will carry out technical cooperation to promote the activated coke dry process The application of desulfurization and denitrification technology in iron and steel enterprises, the signing ceremony of technical cooperation between the two parties was successfully held recently at the Chinese Institute of Metals.

NM450 steel elongation, Special thick steel plate cutting needs to be preheated in advance. Some steel plates are prone to cracks after entering the cutting process, sometimes that is because the temperature is too low, and it is necessary to perform pre-heat treatment in advance for such cases. The staff can preheat the steel plates first, so that the temperature of the steel plates will gradually increase, and then the flame gun can be used to cut. The probability of cracks in the cut material is very low, and the quality of the steel plate is also guaranteed.