Material hardox 400 sheet tensile strength grade density

Erosion wear of wear-resistant steel plates is very common, because rain erosion is an inevitable natural damage. Since the problem cannot be solved from the source, we should take appropriate measures to reduce the damage to a lower level. To this end, we can properly refurbish the wear-resistant steel plate, HARDOX 400 sheet tensile strength. The method of electrothermal welding is adopted for the connecting parts of the wear-resistant steel plate, and the plate is well fixed, and the brittleness of the plate is reduced as much as possible. So that the plate can not be damaged when it is subjected to wind and rain.

Primary processing, steel plate cutting processing cutting method, it is a flame cutting, because it to the accuracy requirement of the cutting size is not very high, the thickness of the HARDOX 400 sheet tensile strength plates in a certain range can be a good cutting quality and cutting effect, and the cut surface can be very smooth, however, it is important to note that in this work, is the need to pay attention to steel plate deformation at high temperature.

Available steel plate types: HARDOX 400 sheet tensile strength, carbon structural steel plate, low alloy high strength steel plate, bridge steel plate, building structural steel plate, shipbuilding and offshore platform steel plate, boiler and pressure vessel steel plate, mold steel plate, alloy structural steel plate, oil and gas transmission pipeline steel plate, high strength and high toughness steel plate, corrosion-resistant steel plate, composite steel plate, wear-resistant steel plate, etc.

The effect of alloy elements on the properties of heat treatment methods for thick steel plate: the performance of heat treatment method reflects the difficulty coefficient level of heat treatment process and the tendency of defects caused by heat treatment process. The key points include cutting performance, over temperature sensitivity, quenching aging tendency and air oxidation carburizing tendency. HARDOX 400 sheet tensile strength, Carbon steel has high machinability, and slow cooling method can be used in heat treatment, which can reduce the deformation and cracking tendency of the products. The addition of Mn and Si will increase the over temperature sensitivity of steel.