The market demand for hardox 500 vs ar500 is increasing

A514 steel plate is high strength weldable steel quenched and tempered according to ASTM standard. ASTM A514 steel plate is mainly used in places where HARDOX 500 vs ar500 high tensile strength and high yield are required. The lifting gears of engineering vehicles, and racks for offshore platforms generally use A514 grade Q or A514 Gr Q. The HARDOX 500 vs ar500 hardness of A514 steel plate is between 235-290. A514 steel yield strength is more than 630MPa, and tensile strength is more than 700MPa. A514 steel plate is difficult to process. In the United States, the use of A514 steel plate is very large.

Our company is a large HARDOX 500 vs ar500 steel enterprise integrating steel plate production, sales and processing. It is a first-class agent of Shanxi Taigang, Shanghai Baosteel, Jiugang, Xi'an Huaxin, Taishan steel, Dongfang special HARDOX 500 vs ar500 steel and southwest special steel. It is a special dealer of famous steel plants in China, such as Columbus, NAS, acerinox, Outokumpu, Arcelor, nipponmetalindustry, nipponyakinkogyo, NSC, etc.

S355J2 steel plate HARDOX 500 vs ar500 rolling process is controlled rolling process. In the rolling process, the ingot rolling temperature is 1000-1050℃; in the first stage, the low-speed and large reduction rolling process is adopted, the high-temperature stage is 950-1000℃, the rolling speed is 1.6-2.0m/s, the HARDOX 500 vs ar500 single reduction rate is 15-20%, and the cumulative reduction rate is 40-45%, so as to ensure sufficient deformation of ingot. In the first stage, the start rolling temperature is 910-930℃, and the finish rolling temperature is ≤ 870℃.

Alloy steel means that alloy elements are specially added to improve the properties of steel. For example, nickel can improve the strength without reducing the toughness of steel; chromium can improve the hardness, corrosion resistance and wear resistance of high carbon steel. The properties of HARDOX 500 vs ar500, alloy steel depend not only on chemical composition, but also on proper heat treatment to a greater extent.

We should focus on the main problems to be solved and pay attention to efficiency. After receiving the user's quality objection report data, the possible causes, responsible units, compensation amount, etc. of the problem shall be judged based on experience. To have a clear service plan, to be clear about what your main problem is, what technical support is needed, these should be prepared.