Latest price of nm500 steel equivalent

NM400 wear plate is widely used in mining machinery, coal mining machinery, environmental protection machinery, engineering machinery and other product parts. Such as excavator, loader, bulldozer bucket plate, blade, side blade, crusher liner, etc.. NM400 wear plate is also commonly used as high-strength structural steel with yield strength ≥ 800MPa. The main function of NM400 wear plate is to provide protection in places or parts where wear resistance is required, so as to prolong the service life of the equipment.

Preheating cutting: The most effective way to prevent steel plate cutting cracks is to preheat before cutting. Before flame cutting, the steel plate is usually preheated, and the preheating temperature mainly depends on the quality level and thickness of the steel plate. The preheating method can be carried out with flame burner, electronic heating pad, or heating furnace. In order to determine the preheating effect of the steel plate, the required temperature should be tested at the heating point.

Medium and thick plates NM500 steel equivalent are mostly used in construction engineering, machinery manufacturing, container manufacturing, shipbuilding, bridge construction, etc. Medium and thick plates can also be used to make all kinds of containers, furnace shells, furnace plates, automobile static steel plates and so on. Among them, shipbuilding steel plate is used to make marine and inland ships. The shipbuilding steel plate NM500 steel equivalent is required to have high strength, plasticity, toughness, good cold bending performance, welding performance and corrosion resistance.

Z-direction steel refers to thick steel with good tensile resistance in thickness direction. In the application of steel plate, the reason for additional performance requirements on the thickness direction of steel is due to the existence of defects in the thickness direction of steel in the process of casting and rolling. This defect makes the steel prone to lamellar tearing during welding, which reduces or even loses the design bearing capacity of application. The Z-direction performance is required for NM500 steel equivalent and so on steel plate with the tensile force along the plate thickness direction greater than or equal to 40mm.