Effect of S content fluctuation on mechanical properties of nm400 material specification

The difference between cold rolled steel sheet and hot rolled steel plate. The carbon content of NM400 material specification, hot rolled steel plate is slightly higher than that of cold rolled steel sheet. In the case of little difference in composition, the density of cold rolled steel sheet and hot rolled steel plate is the same. Hot rolled steel plate has characteristics of low hardness, easy processing and good ductility. Cold rolled steel sheet has high hardness, and it is relatively difficult for processing. But it is not easy to deform and has high strength. Hot rolled steel plate can be made into alloy steel plate by adding other elements, and its properties are also excellent compared with other high-quality steel plates.

When talking about our team, it is hard not to mention our QC department (Quality Control). We have built strict qualitycontrol system to guarantee the steel quality. During the steel materials production, we have strict monitoring measures and indicators, and ensure no chemical composition, mechnical properties and so on technical problems for the steel materials NM400 material specification. After production, our QC department will conduct another inspection regarding to the steel quantity, dimension, mark and so on points before delivery.

NM400 material specification Weldability refers to the performance of the weld joint with the expected quality requirements obtained by common welding methods under specific structure and process conditions. Weldability is generally judged by the crack sensitivity and the change of mechanical properties of weld zone. The ability of steel materials to withstand bending without cracking at room temperature is called cold bending. The greater the bending capacity before crack, the better the cold bending performance of the steel material.

The secondary quenching and low temperature tempering of wear resistant composite plate are mainly used for high alloy steel workpieces without mechanical processing after carburizing. Carburizing, high-temperature tempering, one-time heating quenching, low-temperature tempering, quenching temperature 840-860℃, mainly used for Cr Ni alloy carburizing workpiece. The second quenching and low-temperature tempering of wear-resistant composite plate, NM400 material specification mainly improves the microstructure of the infiltrated layer. When the requirements for core properties are not high, quenching can be performed between AC1 and AC3, and when the requirements for core properties are high, it should be quenched above AC3.